CS2-170 Saw | Inductotherm Group Japan Ltd.
×

CS2-170 Saw

For precision milled cuts on product up to 6.625 inch (170 mm) diameter, the Alpha™ CS2-170™ two bladed cold saw performs at speeds up to 265 feet per minute (80 mpm). The blades for the CS2-170™ saw are driven by two heavy duty 40 HP AC servo motors and are monitored through speed feedback control to maintain constant speed and torque through the cutting cycle. The result is a precision milled cut for large diameter tube and pipe.

REQUEST A QUOTE »

Inductotherm Group Japan Ltd.

3-10 Minamibefu 1-chome, Nishi-ku, Kobe 651-2116 Japan

  • Phone: 078-974-2552
  • Fax: 078-974-6535

Features

  • Rack and pinion for accurate cut length
  • Tracking wheel or laser tracking of tube speed available
  • Dynamic home saw positioning to maximize production capability
  • Helical gear spindle for low-backlash positive blade drive
  • Low vibration blade drive system
  • Manual and automatic blade set-up
  • On-center hydraulic tube clamping
  • Control system includes full simulation mode
  • Crop and Test cutting capability
  • Message/report system for fault diagnostics and troubleshooting

Tech Specs

The following chart shows achievable mill speeds for 0.100 in (2.5 mm) wall product. Additional cutting specifications available upon request.

20ft (6m) Tube 40ft (12m)
 Outer Diameter Speed Speed
2.375in (60.3 mm) 151 ft/min (46 mpm) 265 ft/min (80 mpm)
3.5in (89 mm) 135 ft/min (41.1 mpm) 226 ft/min (68 mpm)
4.5in (114 m) 127 ft/min (38.7 mpm) 219 ft/min (66 mpm)
6.625in (168 mm) 114 ft/min (34.7 mpm) 205 ft/min (62 mpm)